Products Catalogue Home     |     About Us    |     Retrofit     |     Download     |     News     |     Tech Support     |     Contact Us     |     
ppr fittings-NF-4011-Newsun Industry Co., Ltd
Home > Tech Support >

Tool Change Time Too Long


We have a lathe machine with 980TA control and 6 station tool turret, now we want to change it to 4 station tool post, No.84 paremeter of GSK980TA has been set, and

pull-up resistors are added. The problem is CNC always alarm when we tried to manual change the tools, and only No.3 tool can be selected, alarm information: Tool

change time too long.


CNCmakers Support:
Could be the tool signal was not received, the position of the inductive sensor and the magnets are not match, you could try to adjust the sensor position and try again.



—[Close]— —[ Back]— —[ Print]—