Products Catalogue Home     |     About Us    |     Retrofit     |     Download     |     News     |     Tech Support     |     Contact Us     |     
ppr fittings-NF-4011-Newsun Industry Co., Ltd
Home > Tech Support >

Illegal S code



Many thanks for your service and reply.

I fix that error. Now all the axis are working according to the program except spindle. When i try to run the spindle using M03 in MDI mode there is no response. When i press the spindle CC and CCW keys on operation panel then also there is no response. When i give M03  S500 in MDI mode then there shows an alarm that is " Illegal S code".

1) Why is it so?

 2) Do i need to change any parameters?

3) What all parameters need to be checked?



CNCmakers Support:

Please change bit parameter 001, SPT=0 (frequency conversion or others)

Please refer to Page 278 of below manual.


—[Close]— —[ Back]— —[ Print]—