The height of the turret and the center of the spindle is deviated; the position of the servo turret is not accurate; the seals of the linear shaft guards are damaged; the numerical control system and the pipeline are aged;

Need to replace the supporting CNC system, restore the accuracy of the machine, replace the aging parts, install the automatic chip conveyor, and install the pneumatic door.

solution

The GSK 988T CNC system is used, and the servo motor and servo drive are used for transformation;

Adjusting the spindle base and the turret to ensure that the spindle and the center of the turret are of the same height;

Repair the turret, replace it with a wide-number servo motor to drive the turret rotation; fine-tune the position of the detection switch to ensure accurate tool change position;

Replace the shaft seals of each shaft to protect the shaft screws and guide rails;

Increase the chain plate type automatic cooling chip removal system, the chip conveyor is installed under the whole machine cover, and the chip is discharged from the right side of the machine;

Adding a pneumatic door with a switch door in-position detection signal;

Overhaul chucks, hydraulic, lubrication, cooling, pneumatic systems and replace worn parts;

Redesign the machine electrical control schematic, replace electrical controls and electrical components and re-route.