Products Catalogue Home     |     About Us    |     Retrofit     |     Download     |     News     |     Tech Support     |     Contact Us     |     
ppr fittings-NF-4011-Newsun Industry Co., Ltd
Home > Tech Support >

GSK983Ma-H-4R Absolute Z position display


GSK983MA-H-4R User:

I have a parameter question, how do I make it so the Absolute Z position display is not affected by G43 tool length offset.


For example,

Tool #1 offset = 6.000”





Then Absolute Position display says Z10.000 not Z4.000

I looked though parameters in manual and could not find the one to change.



CNCmakers Support:

Yes, there is no parameter setting for this, the software is designed to display the value of coordinate + length offset, it cannot be set by parameters.


—[Close]— —[ Back]— —[ Print]—