Products Catalogue Home     |     About Us    |     Retrofit     |     Download     |     News     |     Tech Support     |     Contact Us     |     
ppr fittings-NF-4011-Newsun Industry Co., Ltd
Home > Tech Support >

Driver Has No Enable Signal


We have a CNC lathe with GSK928TEII controller, the X and Z drivers are not

enabled and no any alarm, the mainboard input power 24V and 5V are tested

normal, we think it is mainboard problem, the question is which part of the

mainboard could cause such situation? thanks.


CNCmakers Support:
Please you could test the driver Enable by grounding first, then we can confirm

if the problem comes from CNC or driver? if it is CNC problem then most

probably is IC 2803 inside the GSK928TEII is burned.

—[Close]— —[ Back]— —[ Print]—